Lync for mac override photo install#
Lync for mac override photo software upgrade#
Lync for mac override photo upgrade#

If desired the web management interface can be disabled again to prevent any remote access to the phone.

Lync for mac override photo upgrade#

The phone will reboot a couple of times as the upgrade process completes and then will return to the default home screen. Select the latest version and then confirm the process.Select the Check for Updates button to check the hosted server for the available versions.

Lync for mac override photo software upgrade#

Browse to the Utilities > Software Upgrade menu and verify that the Server Type is set to Polycom Hosted Server.

(If Internet Explorer 11 is used then it may be required to add the IP address to the Compatibility View list if getting stuck at this menu.)

Leave the Login As value at the default setting of Admin and then enter the default administrator password of ‘456’.

Note the IP address and then connect to that address in a web browser.

Press the Home key on the phone and then navigate to the following menu: Settings > Status > Network > TCP/IP Parameters.Once the phone has completed rebooting the device’s IP address can be retrieved directly from the phone to use for connecting to the web management UI. Back out and select Save Config which should trigger a reboot of the phone to apply the change.Change the Web Server parameter to Enabled and the Web Config Mode parameter to whichever combination of HTTP and HTTPS is desired (e.g.Note that the phone’s embedded Web Server is disabled now that Lync Base Profile was activated. Also the Web Server Configuration item is located at the bottom of the Administration Settings menu. When prompted to enter a password on the Advanced menu enter the administrator password configured on the phone (the default value is ‘456’). Press the Home key on the phone and then navigate to the following menu: Settings > Advanced (Enter Password)> Administration Settings > Web Server Configuration.

Lync for mac override photo install#

If the web management interface is not currently enabled then it must be turned on temporarily in order to install an update directly from the public Polycom update server. In order to access the web interface then it must first be re-enabled from the phone (or remotely via a provisioning server configuration file if desired). Enable Web UIĪs of the previous version’s 3PIP qualification the phone’s web management user interface is now disabled by default whenever Lync Base Profile is enabled.

The easiest way to update a single phone to get started testing out the new features is to use the web server interface on phone to download and install the latest version from a Polycom hosted server over the Internet. Prior to using any of the new features a VVX handset will need to be upgraded to the 5.3 software release.Īs covered in past articles there are various ways to upgrade the firmware using a centralized distribution point like the Lync Device Update service. Not all of the features are covered, so make sure to also look for the upcoming administrators guide for release 5.3 for full details. There are a lot of new Lync specific features, some of which are highlighted in this article. The newest release of Polycom VVX firmware is now available as the 5.3 UCS release.